gdglatfelter
Member
In a couple of instances now when squaring the ends my blanks have heated up during the squaring process so much that the pen tube is loosened and moves.
I am holding the blank in a vise, using a fairly new (sharp?) pen mill, and a drill press.
I am thinking that maybe I haven't roughed up the tube enough and it isn't bonding well or maybe not enough CA (am using med viscosity CA). Any suggestions on what I might be doing wrong?
Thanks
Gary
I am holding the blank in a vise, using a fairly new (sharp?) pen mill, and a drill press.
I am thinking that maybe I haven't roughed up the tube enough and it isn't bonding well or maybe not enough CA (am using med viscosity CA). Any suggestions on what I might be doing wrong?
Thanks
Gary