Hillbilly
Member
This will be my first rollerball pen. I have only turned slimlines. In the directions for this pen it says on the longtube "cap end" to make a 1/4 inch parting cut to accept the center band.
My question is.....how crucial is this cut? Do you take the 1/4 off in one cut or 1/16 to 1/8 at a time. How hard is it going to be to get a square end?
Thanks in advance for any suggestions.
My question is.....how crucial is this cut? Do you take the 1/4 off in one cut or 1/16 to 1/8 at a time. How hard is it going to be to get a square end?
Thanks in advance for any suggestions.