gerryr
Member
This started out to be a plain vanilla Americana pen with Brown Mallee burl. The first thing to go was a large chip near the tip that went all the way to the tube(I didn't use CA on the ends first). No problem says I. I cut a small piece of Red Mallee burl and put it together and back on the lathe. Then I turned the upper barrel a bit too small so the CB was going to be obviously too big and have a sharp edge. Back to the Red Mallee burl again although making a new CB and making fit properly was a lot harder this time.
Any comments or suggestions are welcomed.
Thanks
Any comments or suggestions are welcomed.
Thanks