Wolfeman46
Member
I've had a lot of luck with the CA/BLO finish, but I may start looking into different things to just try different methods since I'm new to all this.
My first question deals with something that looks like 0000000000s down the pen after finishing. It doesn't do it on every pen, but it's been quite a few. Am I doing something wrong?
Next question is... I sometimes have something when sanding that looks like metal from the bushings on the ends of the tubes. Is there something I can put on the bushings to stop that?
And last question...what can I do for the ENDS of the pens after I finish them? I keep reading about putting CA on them. How would I do that?
Thanks for any help!
My first question deals with something that looks like 0000000000s down the pen after finishing. It doesn't do it on every pen, but it's been quite a few. Am I doing something wrong?
Next question is... I sometimes have something when sanding that looks like metal from the bushings on the ends of the tubes. Is there something I can put on the bushings to stop that?
And last question...what can I do for the ENDS of the pens after I finish them? I keep reading about putting CA on them. How would I do that?
Thanks for any help!
Last edited: