7mm Cigar Pen

[Dale Allen]

Well, I finally got one done that looks good.
Been playing around with this idea for some time now.
This is a Walnut blank and is built with most of the parts from a roadster kit in gun metal. At about 5/8" in diameter at the top, it is actually not too bad to write with. BTW, the top section is one entire uncut piece.

Dale

 

[mikespenturningz]

Now that is really different. It came out good. Great idea great pen!

 

[alamocdc]

I thought the same thing as Mike, "Now that's different!" I'm not sure I care for the 7mm nib (not that what I care for is important), but you did a good job on it. I'm sure there are those who will love it! Most cigar lovers will for sure.

 

[Fishinbo]

Smoking hot pen !!! Great one.

 

[Dale Allen]

Thanks to all for the kind words.
Billy, I'm not a fan of the nib on the end either.
However, this was just a prototype and an attempt to create a cigar replica that uses less expensive hardware and is easier to make. I don't know that I would necessarily make another.
Sometimes I just need to complete one to see how it looks.
I also forgot to seal the label on this one and the CA caused a watermark. Oh well!

 

[Jgrden]

Thanks to all for the kind words.
Billy, I'm not a fan of the nib on the end either.
However, this was just a prototype and an attempt to create a cigar replica that uses less expensive hardware and is easier to make. I don't know that I would necessarily make another.
Sometimes I just need to complete one to see how it looks.
I also forgot to seal the label on this one and the CA caused a watermark. Oh well!

Watch for Martin's Pens. That guy makes a cigar pen that you want to light up.