scotirish
Member
These are the only two of these I will ever use. They are very hard to put together. Notice the one on the right has no Trim Ring on the bottom of the Upper Barrel. This is because the Trim Ring falls off and instructions tell you to use a "drop" of ca glue to keep it on. :redface::redface: The one of the left took six "drops" before it stuck together. The right one was stuck until I tried to press on the Clip Retaining Coupler then came off and was crushed. Speaking of the Clip Retaining Coupler it is very hard to insert, it is an extremely tight fit into the end of the Click Mechanism and takes a great deal of strength to get it to go in. That aside, the one on the left is made with a "Jim Beam" blank and the one on the right with Red Gum.
On that I would suggest you try one as I may have been the problem. :redface::redface:
On that I would suggest you try one as I may have been the problem. :redface::redface:
Attachments
Last edited: