Hey Guys, still have problem with ca... i get the part down to size and sand up to 400. then i apply ca with paper towel 1 layer at a time and wait about 1-2 mins between layers and do about 15-20 layers. but when i go to wet sand it gets white and to sand it off i have to use 400 grit which sands away all the finish... what am i doing wrong im using the lee vally hot stuff glue? should there be a differnt glue that works betteR??
Hi Chris,
You need to read
this thread carefully, and take particular attention to my post #30.
You are falling in the same "trap"...!, times between coats...!!!, sanding/wet sanding after last coat applied...!!!, accelerator yes/no, too much of it, not enough...! yep, sure but, what are the temperatures like at the application location...??? absolutely no mention of it and that will determine more that what you may think...!
There are plenty of threads about the CA issues and you should invest a little time in learning/discovering the mistakes we all done and why. Take it all in, digest it to your circumstances and squeeze the good juices, you my surprise yourself with what you will find...!
Good Luck,
Cheers
George