micromesh

Signed-In Members Don't See This Ad
  1. T

    Sand between CA coats, or sand once at the end?

    The way I've been doing it is to add 2 layers of thin CA, then run through my micromesh pads lightly once. Then I add a medium CA coat, run through the pads again, then another coat, pads, and so on, until I'm happy with the finish. Question: Do I need to be sanding with the micromesh in...
  2. M

    Polish or Wax after MM 12000 ?

    I have achieved great results wet sanding the CA finish with Micromesh up to 12000. I am thinking that I could apply a wax or polish to it at the end but I do not want to use anything with any grit to it because the finish is already quite glossy. Are there any recommendations for a car wax or...
  3. BSea

    Micro Mesh Problem

    I recently replaced my old Micro Mesh pads with a new set. Both sets were bought from woodcraft. The old set worked great till the pads finally wore out. The new set doesn't seem to be of the same quality. The abrasive layer is pulling away from the foam pad, and I'm getting small pieces...
  4. Culprit

    Sorting MicroMesh - Colorblind or Not

    A few months ago a guy mentioned here on the IAP that one of the reasons he didn't use MicroMesh was that he is colorblind and couldn't keep the pads in the right order, and that he was tired of constantly asking his wife or someone else to sort them for him. I'm not colorblind, but I don't...
Top Bottom