high gloss

Signed-In Members Don't See This Ad
  1. B

    plastic polish

    three questions on finishing.... 1. What is everyone's favorite plastic polish? and 2. When do you use it? (after 12000 MM as a last step, or after 6000 MM then buff etc....) 3. What do you apply it with/buff it with?
  2. B

    Finishing allumite swirl/burl blanks

    I would like to find out what techniques folks are using to finish the swirl blanks ankrom et al sell. Here's my method: 1. After turning, sand with 320 abranet. 2. Stop lathe and sand lengthwise until all circular scratches are gone and you have lengthwise scratches 3. repeat 1-2...
Top Bottom