candy1land
Member
I've seen that many of you have made the breast cancer pen kit that goes on the Sierra's.
I was hoping someone could clarify the instructions for that kit for me.
The instructions say to flood the wood with thin CA and then insert and glue the brass tube.
I'm trying to visualize how that will work since the ribbon is a cut out and will have nothing against it to keep it in place while the thin ca dries?
I keep thinking I should glue the tube first and then flood the blank with the thin ca?
I'm only stuck on the first steps so if you can walk me thru it I would greatly appreciate it. I really want to make this pen kit.
Thanks,
Candy
I was hoping someone could clarify the instructions for that kit for me.
The instructions say to flood the wood with thin CA and then insert and glue the brass tube.
I'm trying to visualize how that will work since the ribbon is a cut out and will have nothing against it to keep it in place while the thin ca dries?
I keep thinking I should glue the tube first and then flood the blank with the thin ca?
I'm only stuck on the first steps so if you can walk me thru it I would greatly appreciate it. I really want to make this pen kit.
Thanks,
Candy