Baron Question

[THarvey]

Does anyone make a pen mill pilot for the Barron cap? My largest is too small to positively square the blank.

Thank you.

Tim

 

[shull]

You can turn one from Oak Dowling.

 

[johncrane]

it's easy to make your own using a 7mm tube then turn the blank the size you want.

 

[its_virgil]

I do.:biggrin::biggrin::wink: I have one 7mm pen mill and turn shims from scrap for each tube size. Each time you need a new on, just stop and make one and label itl. I use wood, others use corian or delrin and even metal for those with a metal lathe. Spend the money for kits or tools.
Do a good turn daily!
Don
]

Does anyone make a pen mill pilot for the Barron cap? My largest is too small to positively square the blank.

Thank you.

Tim

 

[rjwolfe3]

Yep what they say - I use Corian and Delrin and sometimes wood. I think there is someone selling those on the forum if you want to buy them premade.

 

[mbroberg]

johnnycnc sells what you want. Check out http://penturnersproducts.com/index...ath=12&zenid=f2340eabaf5cbd94021ffb51f6f28385

I, and many others on his forum swear by his products.

 

[nava1uni]

hewunch in Business classifieds. Hans sells trimmer sleeves for the Baron for $6.00 a set. I bought some from him and they work great. You should check out his listing.

 

[THarvey]

Thank you everyone.

 

[hewunch]

Just wanted you to have a link. I have sleeves for Baron, Sierra, Full Size Gent, Jr. Gent, Jr. Gent Ballpoint and El Grande. It is found in my signature.
Hans