Kitless Rollerball in two resins

[Bryguy]

Just finished this in Acrylic and Rhino resin.

 

[mark james]

Well done Bryan. I like how you blended the upper and lower sections into a nice joint.

 

[magpens]

I also like how you have done that pen !! . Also, the two resins complement each other nicely !!

 

[John Eldeen]

Nicely done Bryan
Just curious did you drill the hole for the refill just deep enough for the refill or enough for a refill and a spring? If you installed a spring with the refill would you share you source for the spring? I have been toying with the idea of trying a kitless pen but don't really what to do a fountain pen.

 

[Bob in SF]

Beauty!

 

[Ironwood]

Looks good mate. I also like the cap to body transition.
How have you attached the clip ?

 

[Bryguy]

Nicely done Bryan
Just curious did you drill the hole for the refill just deep enough for the refill or enough for a refill and a spring? If you installed a spring with the refill would you share you source for the spring? I have been toying with the idea of trying a kitless pen but don't really what to do a fountain pen.

I used springs ( approx 2.5 mm diam and slightly conical). I think I purchased them through Amazon.

 

[Bryguy]

.

 

[Bryguy]

Looks good mate. I also like the cap to body transition.
How have you attached the clip ?

I drill a hole in the cap slightly smaller than the hole in the clip and thread it. Then I make a finial to fit. Thread the finial and screw it all together.

 

[RobS]

Looks solid, love it

 

[jfr]

I would like to make kitless pens, can you do one how much