robutacion
Member
Please ignore the original pics and question, the answer was accidentally revealed in the pics and I apologise for my mistake...!
Correct images and question on post #7
Hi folks,
I understand that at the moment, IAP is having lots of different challenges and that everybody is busy trying to finish or wrap up these annual events so, my game #39 may come at a less convenient time for some of you so, I will try to make it simple and something that will not require a lot of searching, so I hope...!
On these 2 images bellow, you can see a wood bowl that has warped considerably after finished, the wood wasn't green (spalting) but it was wet from being in the rain for some time.
The questions is;
What did I use, apart from a plywood disc, to secure the bowl on the lathe on this re-mounting...?
Cheers
George
Correct images and question on post #7
Hi folks,
I understand that at the moment, IAP is having lots of different challenges and that everybody is busy trying to finish or wrap up these annual events so, my game #39 may come at a less convenient time for some of you so, I will try to make it simple and something that will not require a lot of searching, so I hope...!
On these 2 images bellow, you can see a wood bowl that has warped considerably after finished, the wood wasn't green (spalting) but it was wet from being in the rain for some time.
The questions is;
What did I use, apart from a plywood disc, to secure the bowl on the lathe on this re-mounting...?
Cheers
George
Attachments
Last edited: