larryc
Member
I noticed that the blade on my bandsaw was rubbing on the right side of the insert.
I took the table off and backed off the guides and rollers and with the blade tensioned, the photos show what is occurring.
The measurement between the blade and the left side of the lower guide block holder is 11/32" compared to 13/64" between the blade and the right side of the holder. About two to one rather than equal distance.
I've checked that the wheels are coplaner but I'm at loss to figure what is causing this problem.
I don't see any way to adjust the lower guide block holder.
This seems to be a problem that has occurred recently and I don't know what caused it or how to cure it.
Any suggestions?
Somehow the right hand photo got flipped on its side when attached and I don't know how to fix that.
I took the table off and backed off the guides and rollers and with the blade tensioned, the photos show what is occurring.
The measurement between the blade and the left side of the lower guide block holder is 11/32" compared to 13/64" between the blade and the right side of the holder. About two to one rather than equal distance.
I've checked that the wheels are coplaner but I'm at loss to figure what is causing this problem.
I don't see any way to adjust the lower guide block holder.
This seems to be a problem that has occurred recently and I don't know what caused it or how to cure it.
Any suggestions?
Somehow the right hand photo got flipped on its side when attached and I don't know how to fix that.
Attachments
Last edited: