Wright
Member
I've turned 2 pens now and I am hooked!! I have a few questions.
1. Should I use the pen mill with a drill press or hand drill? I've seen people using a hand drill in videos.
2. Is it best to cut blanks with a chop saw or ban saw?
3. Is it better to put CA on the tube or in the blank hole? Seen it don both ways on U-Tube.
I'm sure these questions may be personal preference but I'd like to here from you that have been doing this a long time and what works good and not so good.
I will say thank you all for your opinions now. I am honored to be a member of the IAP with great penmakers.
Regards
Lamar
1. Should I use the pen mill with a drill press or hand drill? I've seen people using a hand drill in videos.
2. Is it best to cut blanks with a chop saw or ban saw?
3. Is it better to put CA on the tube or in the blank hole? Seen it don both ways on U-Tube.
I'm sure these questions may be personal preference but I'd like to here from you that have been doing this a long time and what works good and not so good.
I will say thank you all for your opinions now. I am honored to be a member of the IAP with great penmakers.
Regards
Lamar