My kitless kit

Signed-In Members Don't See This Ad
glycerine

glycerine

Member
Joined
Aug 7, 2009
Messages
3,462
Location
Fayetteville, NC
I'm still waiting on a few more taps, dies and fountain pen sacs, but here's what I have so far in my "kitless kit". For now I just keep it all in a cigar box in the drawer under my lathe. I've got a few center drill bits, regular drill bits, some o-rings, silicone grease, taps and dies.
Like I said, I am still waiting on a few more items to come in, but this is what I will have as far as taps/dies/drill bits: Tap for the #5 Bock feeds, I believe it's a 6.4 X .6, and a 5.8mm drill bit for that. Also a 6.8mm and 7.2mm for drilling out sections, 8mm X .75, 9X.75, 10X.75, 12X.75 taps and dies. 7.25mm, 8.25mm, 9.25mm and 11.25mm drill bits. Once I get some experience and if I'm any good at it, then I might grab some triple start taps/dies...

 
Signed-In Members Don't See This Ad
I bought the o-rings originally to convert a Pilot Plumix cartrigde foutain pen to an eyedropper. I can't find the cartridges locally and I thought it would be nice to just be able to use my own inks. I used the o-rings because I wasn't sure if the silicone grease would be enough to keep the threads from leaking.
So, I thought I might need them if I make any eyedropper fountain pens to keep them sealed. It might be overkill, but I think that all depends on how tight my threads are. We'll see if I actually NEED them or not...
 
Jeremy - Silicone should be fine if you use the tighter (finner) threading for the section to body connection. You might ask Joe (turbowagon) as he has done this beofore.
 
You must log in or register to reply here.
Back
Top Bottom