Dvoigt
Member
I purchased a closed end cigar mandrel about a year ago from Arizona Silhouette and the other day when I tried to tighten the mandrel the bolt broke.
I could not get the mandrel tight enough to keep the blank from spinning when the tool contacted it. Anyone have any tips on getting this tight without using bolt breaking force?
Anyone knwo the size of bolt needed to replace it? I was just going to take the broken one to the hardware store and find one that matched.
Thanks,
Derek
I could not get the mandrel tight enough to keep the blank from spinning when the tool contacted it. Anyone have any tips on getting this tight without using bolt breaking force?
Anyone knwo the size of bolt needed to replace it? I was just going to take the broken one to the hardware store and find one that matched.
Thanks,
Derek