boxerman
Member
Where do you get barons kits from i haven't been able to find any or are they called somethings.
Baron Kits
- Thread starter boxerman
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
ldb2000
Member
They are also available as the Navigator from PSI and others and there is another clone but I can't think of the name right now .
its_virgil
Member
http://www.arizonasilhouette.com has the best selection
Navigator at woodcraft in limited platings
http://www.bereahardwoods.com
The tycoon somewhere but I can't recall.
The new Vail at http://www.beartoothwoods is very similar
The jr gent at http://www.woodturnerscatalog.com is also similar
Do a good turn daily!
Don
Navigator at woodcraft in limited platings
http://www.bereahardwoods.com
The tycoon somewhere but I can't recall.
The new Vail at http://www.beartoothwoods is very similar
The jr gent at http://www.woodturnerscatalog.com is also similar
Do a good turn daily!
Don
boxerman
Member
Thanks alot for the info. guys i will check the sites out.
ldb2000
Member
Oops, Tycoon from PSI and Navigator from woodcraft . Well.....I was close
its_virgil
Member
I looked and didn't see it on their website. Maybe I just missed it. That's why I didn't commit...just knew someone called it the tycoon.. I thought maybe Rockler but it isn't there either. Oh well....he now has lot of choices.
Do a good turn daily!
don
Do a good turn daily!
Don
Do a good turn daily!
don
Do a good turn daily!
Don
ldb2000
Member
The only problem with the clones are they only come in the cheap platings . AS has the Baron in all the best platings and the prices aren't bad .
Yes the Tycoon is listed on their page , I thought I was wrong about the navigator as I was posting it so I went to check it .
Yes the Tycoon is listed on their page , I thought I was wrong about the navigator as I was posting it so I went to check it .
dl351
Member
I got a couple Tycoons and Navigators a month or two ago. Does anyone have a problem with the 15/32" drill bit making a hole that is too large? I've only drilled a couple of them, but that drill bit seems a little to large for the tubes. Then again, maybe my drill press has too much run out.
DurocShark
Member
I have become a fan of the Navigator FP, at least in sterling silver.
The faceted grip on the rollerball is a major turn off for me.
As for drilling, I haven't had any trouble with the 15/32". But I drill on the lathe.
The faceted grip on the rollerball is a major turn off for me.
As for drilling, I haven't had any trouble with the 15/32". But I drill on the lathe.
jaywood1207
Member
Don't forget to check out www.penblanks.ca Great to deal with and great prices.