MIKL
Member
just like the last one, i spent a couple of hours bending and shaping watch gears by hand.... definitely gotta get me one of those shaping blocks
this one i dressed up a little with just a hint of red wire and a Date Circle
this time i used a Zen component set in Chrome plating, i would have preferred to go with a Black Ti or Gun Metal but i had none left, guess i will have to order some more
It was cast at the same time as my previous post but needed some attention due to silicon molds and pressure, you can see in the pickie how much the molds compress under 45psi, i will not use these in the pressure pot again, instead i am trying out another idea as i type
thanks for looking, C&C encouraged
MIK
this one i dressed up a little with just a hint of red wire and a Date Circle
this time i used a Zen component set in Chrome plating, i would have preferred to go with a Black Ti or Gun Metal but i had none left, guess i will have to order some more
It was cast at the same time as my previous post but needed some attention due to silicon molds and pressure, you can see in the pickie how much the molds compress under 45psi, i will not use these in the pressure pot again, instead i am trying out another idea as i type
thanks for looking, C&C encouraged
MIK