Builderguy
Banned
I am planning to switch to turning and finishing between centers. I just have 2 questions:
1. What exactly do I need? I know I need a 60 degree revolving center for the tailstock, but do i need a morse taper dead center for the headstock? Where can I get one?
2. If I don't use bushings, can I actually turn it between centers? It seems like the blank would not be very tight and would slip, especially when turning the corners off the blank.
Any input would be appreciated. Thanks!
1. What exactly do I need? I know I need a 60 degree revolving center for the tailstock, but do i need a morse taper dead center for the headstock? Where can I get one?
2. If I don't use bushings, can I actually turn it between centers? It seems like the blank would not be very tight and would slip, especially when turning the corners off the blank.
Any input would be appreciated. Thanks!