Mason Kuettel
Member
I tried a few new things to complete this stylus.
1st: Trustone. Never used it before, so why not start with segments!
2nd: Lengthwise segments. Never tried to segment down the length of the body of a turning. Main reason is that I can never seem to get the perfectly flat surface to work with.
3rd: Copper spots. Used electrical wiring and drilled small holes to fill with the wire. Had a couple of tear outs with these, going to try some things different next time.
Anyway, since it didn't happen if I don't have pics I snapped some quick ones before it was put in a gift bag at the in-laws house (it was a gift for my FIL).
1st: Trustone. Never used it before, so why not start with segments!
2nd: Lengthwise segments. Never tried to segment down the length of the body of a turning. Main reason is that I can never seem to get the perfectly flat surface to work with.
3rd: Copper spots. Used electrical wiring and drilled small holes to fill with the wire. Had a couple of tear outs with these, going to try some things different next time.
Anyway, since it didn't happen if I don't have pics I snapped some quick ones before it was put in a gift bag at the in-laws house (it was a gift for my FIL).