jbswearingen
Member
I recently built this pen, and followed the instructions (I found at Woodcraft) to assemble it. My problem is that the upper turned part doesn't securely attach to the transmission; almost as if it were too long. There's a short section of brass tubing in the kit that I cannot figure what to do with; there are no notes about it. It will slide over the transmission as a loose press fit.
Any advice?
https://www.exoticblanks.com/index....eyword=bullet&option=com_virtuemart&Itemid=60
Instructions I found:
http://www2.woodcraft.com/PDF/77C73.pdf
Any advice?
https://www.exoticblanks.com/index....eyword=bullet&option=com_virtuemart&Itemid=60
Instructions I found:
http://www2.woodcraft.com/PDF/77C73.pdf