bluesguitar
Member
I recently scored a nice drill press on craigslist. In addition to drilling my blanks I've been setting it up with my barrel trimmer but a few times it has dislodged the epoxied tube and I'm trying to figure out why.
I can see there is some glue on the shaft of the trimmer and I've tried to get it off but that didn't seem to help. Is the concept of using the trimmer in the press ok? Maybe I should just replace the trimmer shaft?
I can see there is some glue on the shaft of the trimmer and I've tried to get it off but that didn't seem to help. Is the concept of using the trimmer in the press ok? Maybe I should just replace the trimmer shaft?