byounghusband
Member
I got a Clear Alumilite Resin and cut offs blank from Jake Thompson. I made 2 Sierras out of it, well, one and this. I painted theinside of the blank, but the paint was either too cold or the epoxy and paint didn't get along. As I was turning it, I felt a strange spot on it, that I figure would turn away. Nope!! It lokes like with soft epoxy, or bad glue job, or I don't know. Anyway, This is what I have and I want to fix this. The repaired spot will live under the clip in the Sierra pen, but I need some ideas on the fix.
I have to make it more solid with thin CA, then:
1. more CA and wood dust
2. More CA and Key shavings from Home Depot. I fille din some voids in a pepper mill many years ago that turned out quite nice.
3. How about maybe UV Resin?? I have never tried that and thought it might be a possible fix with some material in it as well.
What do you think?? I just hate to see a good blank go to waste!!
I have to make it more solid with thin CA, then:
1. more CA and wood dust
2. More CA and Key shavings from Home Depot. I fille din some voids in a pepper mill many years ago that turned out quite nice.
3. How about maybe UV Resin?? I have never tried that and thought it might be a possible fix with some material in it as well.
What do you think?? I just hate to see a good blank go to waste!!