WriteON
Member
Just got a new Jet 1015VS. The bottom of base (legs) are not 100% level/flat to each other. Lathe has a slight rock on the bench top. I shimmed and it's stable. I don't think the entire frame/base is off...just the footing. I can live with it if everything else is ok.
The main questions is the Break In. I do not see anything in the operator manual. I did not "break in" my other Jets. Is it necessary to run without a load for a while before using. It will only be used for pen blanks. Thanks, Frank
The main questions is the Break In. I do not see anything in the operator manual. I did not "break in" my other Jets. Is it necessary to run without a load for a while before using. It will only be used for pen blanks. Thanks, Frank
Last edited: