Joe Burns
Member
Ive been using a barrel trimmer to trim the edge of the banks I put on the lathe. I dont have a disc sander available that I could use for this.
I have a set of JohnU feather blanks and am nervous about trimming the edges for turning. For those who have turned these awesome blanks what would you suggest. A sander is out as long as I'm unemployed. I do have one of the finishing mills for the lathe to trim the edges after applying a CA finish.
Any ideas or suggestions is greatly appreciated.
Joe
I have a set of JohnU feather blanks and am nervous about trimming the edges for turning. For those who have turned these awesome blanks what would you suggest. A sander is out as long as I'm unemployed. I do have one of the finishing mills for the lathe to trim the edges after applying a CA finish.
Any ideas or suggestions is greatly appreciated.
Joe