Bozz
Member
Here is an old drawing and post I did years ago that has given me great service and protected my fingers at the same time. It's been so long since I've posted - I'm not sure I'm doing it right. Anyway, here is my jig, reposted from 2007.
Easy and inexpensive to make. I use this to round off the corners quickly on hard to turn wood to reduce the amount of chip-out and tearing before chucking up a blank on my lathe. Works well for non-wooden blanks as well.
Easy and inexpensive to make. I use this to round off the corners quickly on hard to turn wood to reduce the amount of chip-out and tearing before chucking up a blank on my lathe. Works well for non-wooden blanks as well.
Attachments
Last edited: