RyanNJ
Member
i have a piece of antler that i would like to drill and i am not sure about how to do this.
also is there a way to make a keychain with a tip of antler?
also is there a way to make a keychain with a tip of antler?
i have a piece of antler that i would like to drill and i am not sure about how to do this.
also is there a way to make a keychain with a tip of antler?
Where do you get the ends you are using on the antler leftover pieces for key rings?
Check with your local deer processing place or with hunters. Most of them will have a small rack they dont care about if it means getting a pen in trade. If you can get a nice average rack it will leave plenty for a few pens and key chains. Also, check with your local IDOT, County Highway, or Deputy. They pull dead deer off the road all the time. You can buy it off of some sites. I know exoticblanks.com carries different species of deer antler, also ebay if you trust the purchase and dont get gouged too bad on shipping. Then again, theres always a chance a member will be willing to trade you on this site. Good luckwhere do you buy the antler?
Would epoxy be better than hot glue