Great looking currency blank and pen. Would you mind explaining the process of how you made the blank? I would love to learn.
This is how I do it:
1. Spread the shredded money out on a piece of glass
2. Sand a Sierra tube with 320 grit
3. Install a snug fitting dowel in one end of the tube
4. Spray the tube with Elmer's spray adhesive
5. Roll the tube through the shredded money applying pressure with the palm of the hand
6. Spray the money covered tube with Elmer's spray adhesive and roll through shredded money
7. Repeat #5 & #6 until the brass tube no longer shows through the shredded money
8. Remove the dowel and trim the ends flush with the tube
9. Saturate the shredded money with Thin CA
10. Let dry over night
11. Snip any loose shredded money ends the may be sticking up around the blank
12. Cast in Resin Saver Mold using Polyester Resin
Les