TellicoTurning
Member
So as to not hijack Cav's thread, I have another question on the air cleaners..
My shop is also a 12x24 and the back wall sits facing a wooded area. My closest neighbor is behind and above me on the hill maybe about 2000 yards or more away so dust from the shop shouldn't affect them any.
I run a DC and have it connected to all my major tools, BS, Lathes, TS... the chop saw and planer I usually take outside anyway.. it's good to live in the country.
I've been thinking I needed an exhaust fan installed in the back wall to change the air and blow any floating dust out.. if I put one in, it would be in the peak of the wall that is just above the lathes and hopefully should catch any dust that the DC doesn't..
For those more knowledgeable than me, what are you thoughts on this idea??
My shop is also a 12x24 and the back wall sits facing a wooded area. My closest neighbor is behind and above me on the hill maybe about 2000 yards or more away so dust from the shop shouldn't affect them any.
I run a DC and have it connected to all my major tools, BS, Lathes, TS... the chop saw and planer I usually take outside anyway.. it's good to live in the country.
I've been thinking I needed an exhaust fan installed in the back wall to change the air and blow any floating dust out.. if I put one in, it would be in the peak of the wall that is just above the lathes and hopefully should catch any dust that the DC doesn't..
For those more knowledgeable than me, what are you thoughts on this idea??