BobBurt
Member
I have a problem getting my Collett Chuck off after I use it...I almost have to beat the **** out of it to get it off....Is there an easier way?????
Thanks
Thanks
Hi Bob; Depending on the dia. of your lathe headstock, put a couple of "O" rings over the threads, then tighten your chuck up to them. The rubber will allow you to loosen the chuck. Cheap, easy, fast: pick two!I have a problem getting my Collett Chuck off after I use it...I almost have to beat the **** out of it to get it off....Is there an easier way?????
Thanks
I've read about people making their own out of plastic from like a water bottle with great success.
If you have dome powdered graphite, dust the parts well with it, and then spin at speed after assembled (but without blanks) to remove excess.