Randy_
Member
A question for those of you who have crafted circuit board pens: Where do you put the seam? Underneath the clip or on the back side of the pen 180° from the clip?
I suspect the most obvious place for it is on the back of the pen; but I wonder??
If you place the seam under the clip, more than half of it is hidden by the clip. Additionally, this leaves a wide expanse of pen surface area on the back of the pen totally totally unobstructed and offering the best display of the circuit board.
This idea is a little radical and probably counter to common practice; but certainly worth considering.
I suspect the most obvious place for it is on the back of the pen; but I wonder??
If you place the seam under the clip, more than half of it is hidden by the clip. Additionally, this leaves a wide expanse of pen surface area on the back of the pen totally totally unobstructed and offering the best display of the circuit board.
This idea is a little radical and probably counter to common practice; but certainly worth considering.