I was elected to be chauffeur for my wife and MIL to the local mall.
While they did their thing, I waited at the Barnes and Noble perusing the selection of magazines. I ran across a woodturning magazine and figured I could probably benefit from reading through it. Inside they had a several page write-up on casting plastics. I found it very informative and might just give it a try. Based on the article, it seems simple enough and I have a few ideas I would like to attempt that are non-pen related.
It will most likely be some time before I get to it, as I need a suitable space for the task. Although, it has been added to list of things to try.
While they did their thing, I waited at the Barnes and Noble perusing the selection of magazines. I ran across a woodturning magazine and figured I could probably benefit from reading through it. Inside they had a several page write-up on casting plastics. I found it very informative and might just give it a try. Based on the article, it seems simple enough and I have a few ideas I would like to attempt that are non-pen related.
It will most likely be some time before I get to it, as I need a suitable space for the task. Although, it has been added to list of things to try.
