LenKaltman
Member
Hi everyone,
Frustrated newbie pen maker needs help.
I was working on a cigar pen made out of buckeye burl with an antique bronze trim. Everything was going GREAT and it was probably going to be the nicest pen I made so far.
Then, when I started to put it together something happened, (not sure what went wrong) and it's just not fitting right. I tried to take it apart, but don't have the tools or skill to get it apart without damaging it.
Could anyone help me out and take this pen apart for me?
If you're in the Cincinnati Dayton area (I'm in Monroe, halfway between the two) I could swing by at your convenience, otherwise I'd be glad to mail it to you.
Thanks!!!!
Frustrated newbie pen maker needs help.
I was working on a cigar pen made out of buckeye burl with an antique bronze trim. Everything was going GREAT and it was probably going to be the nicest pen I made so far.
Then, when I started to put it together something happened, (not sure what went wrong) and it's just not fitting right. I tried to take it apart, but don't have the tools or skill to get it apart without damaging it.
Could anyone help me out and take this pen apart for me?
If you're in the Cincinnati Dayton area (I'm in Monroe, halfway between the two) I could swing by at your convenience, otherwise I'd be glad to mail it to you.
Thanks!!!!
Last edited: