carlor
Member
Hi folks,
I'm working on a Majestic Jr in Amboyna burl. As I was turning it round a bit chipped of one of the ends. Being the, uhm, "frugal" person I am, I'd like to try to save it.
It came off the short barrel which I believe is the cap. I figure I'd need to trim no more than 1/8th of an inch to get past the bare brass tube. Would that affect the fit of the components?
Thanks,
Carlo.
I'm working on a Majestic Jr in Amboyna burl. As I was turning it round a bit chipped of one of the ends. Being the, uhm, "frugal" person I am, I'd like to try to save it.
It came off the short barrel which I believe is the cap. I figure I'd need to trim no more than 1/8th of an inch to get past the bare brass tube. Would that affect the fit of the components?
Thanks,
Carlo.