JonnyFever
Member
All,
I have recently been attempting CA Finishes. Currently, after sanding, I apply the CA to the blank while still between the bushings and on the mandrel. However, when I am done, I find that the bushings end up being glued to the blank and any attempted removal of the bushings ends up cracking the finish. What do you recommend I do to avoid this in the future?
Thanks for the suggestions!
I have recently been attempting CA Finishes. Currently, after sanding, I apply the CA to the blank while still between the bushings and on the mandrel. However, when I am done, I find that the bushings end up being glued to the blank and any attempted removal of the bushings ends up cracking the finish. What do you recommend I do to avoid this in the future?
Thanks for the suggestions!