DRAT
Member
Ok, so how woud you recommend I cut acrylic and ebonite bowling balls down so I can use them as pen blanks?
What are the safety issues I must consider?
Should I use a band saw or my table saw? And, do I need a diamond blade? Should I cut down the middle first or take a sliver off of one side of the ball to create a flat surface so I can cut the remainder of the ball?
What steps should I take to get the most out of the ball, and keep my fingers all at the same time?
Thanks all,
DrAT
What are the safety issues I must consider?
Should I use a band saw or my table saw? And, do I need a diamond blade? Should I cut down the middle first or take a sliver off of one side of the ball to create a flat surface so I can cut the remainder of the ball?
What steps should I take to get the most out of the ball, and keep my fingers all at the same time?
Thanks all,
DrAT
Last edited: