moke
Member
I am really into segmenting now. I have built two sleds for my TS. One is for lengthwise segmenting and the other for crosscuts. I wanted to start simple and do a lengthwise cut add in pick guard and then roll it 90 degees and so the same.
I have a couple of problems.
1. the PR blanks are anything but square ( I am not knocking any blank makers, never having casted I am the last person that will criticize)...I tried to square it up and that was a problem, it sounds like it should be so easy...but just didn't seem to be. I eventually ended up with the pickguard fairly even and square and purpendicluar.
2. I knew that it was very critical to drill exactly at the intersection of that pickguard, and that was easy to see and do, I made a centerpunch spot at those intersections and turned it round and drilled off of those, but I really wanted to add crosscut ends...after gluing those on, how would I know where to drill for exact center?
I hope I made this understandable...I am confused..
Thanks:redface:
I have a couple of problems.
1. the PR blanks are anything but square ( I am not knocking any blank makers, never having casted I am the last person that will criticize)...I tried to square it up and that was a problem, it sounds like it should be so easy...but just didn't seem to be. I eventually ended up with the pickguard fairly even and square and purpendicluar.
2. I knew that it was very critical to drill exactly at the intersection of that pickguard, and that was easy to see and do, I made a centerpunch spot at those intersections and turned it round and drilled off of those, but I really wanted to add crosscut ends...after gluing those on, how would I know where to drill for exact center?
I hope I made this understandable...I am confused..
Thanks:redface: