I have gotten used to it but here is what's happening. I start with 2 coats of thin CA and then 2-4 coats of med CA. After that, I always spray accelerator and it clouds up my finish. I then sand with 4000mm and put about 2-4 more coats of med CA on. Then I MM sand to finish. I have gotten into the habit of using this method. I like using the accelerator in the middle of my finish to ensure the CA is hardened before putting on my last coats. Is there a reason why the accelerator always clouds up after I spray it on? I have sprayed it immediately, waited a minute and sprayed it, but either way I spray it clouds up. I've gotten used to this method but was wondering if maybe I'm applying the accelerator wrong. Thanks for any advice!