Latest activity

A lot depends on your market. Have a FP on display for over a year. Pulling it and replacing it with something else.

Tried cotton swabs but not happy with uneven coats. Got thin spots and had to coat twice. Craft brush did good. Negative on air brush is...

I believe the El Grande roller ball and fountain pen by BereaHardWoods were 13.0mm threads. I remember the components fitting some...

Resharpening is purely dependent on how much wear there is. I look at mine through a B&L microscope and I've seen the wear start to...

In my experience ... the skills required to master air-brushing are no less than the skills to master aerosol paint cans. Expect the...

Paint cans work well. Not sure where you are getting a mess. You lightly spray one side and flip over. May have to give 2 coats. You do...

Acme taps and dies can be had but are hard to find. The taps aren't really suited to pen work because they are quite long, 5" or more...

An intersting concept but I dont know of any one who does that. But in my opinion a set of taps and dies in the correct dimensions is a...

I resharpen all mine on a 600 grit diamond card. Always works for me and they feel and cut like new.

Here’s what I could find: - ANEGOLD - Anelli Gold (10) - Woodcraft 7mm Round Top Platinum (27j - PKMONTGUN Gunmetal (12) -...

Have used aerosol paint and it's messy. Also painted the inside with a cheap craft brush, too. Thinking air brushing might be better...

Sweet turning, and I compliment you on accommodating Wolf Creek Knives request; very nice response!

Okay,here you go:)

Very nice. I appreciate the use of ebonite as it is a less appreciated material, but historically important. Very nice.