Latest activity

Signed-In Members Don't See This Ad
  • Paul in OKC
    Paul in OKC reacted to jeff's post in the thread Joanne Jackson with Sad Sad.
    Ohio members will remember Bob Jackson @bobjackson who passed away in March 2020. Bob was instrumental in keeping the Ohio IAP chapter...
  • M
    Mortalis replied to the thread Phillip Head Driver bits??.
    Many of my Square drive bits (Kreg Pocket Hole) have worn down over the years and dont drive the screws anymore. Maybe just a cheap...
  • M
    Mortalis reacted to leehljp's post in the thread Phillip Head Driver bits?? with Like Like.
    I am OLD school with this - I have not had much of a problem with Phillips head because of how I started out. I bought a couple of EARLY...
  • M
    Mortalis replied to the thread Beartooth Woods.
    Yes, 10 second verification check then into their website. Phone works as well.
    • 1775914777365.png
  • M
    Could be. I saw that kit on their website but I could swear there was more to the inscription than what is on the center band.
  • Woodchipper
    Woodchipper replied to the thread Phillip Head Driver bits??.
    I was browsing through a Woodcraft catalogue. Many of the screws shown have the square drive.
  • mark james
    mark james replied to the thread Back At It.
    Very nice set. 👏 👏 Thanks for sharing.
  • mark james
    mark james reacted to jhawth25's post in the thread Back At It with Like Like.
    I have not done much turning, but I finally decided to turn a few pens to put on my
  • KMCloonan
    KMCloonan reacted to COUTURE's post in the thread Decaying leaves with Like Like.
    … These leaves, fallen to the ground, have followed their natural cycle of decomposition. Slowly, the material transformed, weathered...
  • Monty
    Monty replied to the thread Beartooth Woods.
    Funny, my computer has no problem but my phone still the same problem.
  • GaryMGg
    GaryMGg reacted to jhawth25's post in the thread Back At It with Like Like.
    I have not done much turning, but I finally decided to turn a few pens to put on my
  • jttheclockman
    jttheclockman replied to the thread Beartooth Woods.
    I just tried. 9:06 Fri. 4/10/2026. Got right in within a second. No problem here.
  • jttheclockman
    jttheclockman reacted to bugradx2's post in the thread Gnomes???? with Like Like.
    I'd be willing to make a ton of these but they'd never leave my house as my wife has quite a collection going already. Perhaps that...
  • mark james
    mark james replied to the thread Beartooth Woods.
    I was able to get in: 8:33 PM. All materials were ava.
  • leehljp
    leehljp replied to the thread Phillip Head Driver bits??.
    I am OLD school with this - I have not had much of a problem with Phillips head because of how I started out. I bought a couple of EARLY...
Back
Top Bottom