Latest activity

I've done this several times in the past - usually when I was using CA to glue the tubes in and a tube would seize up before it was...

Try to minimize, but you still need a solid layer of epoxy. I did this several times - a rat-tail file got the excess out with little...

Dave, I have a good supply of modeling clay. I do wipe the end of the tube as the clay seems to leave a bit of an oily residue. If I get...

That's what I am thinking, with the cutting edge on the opposite side of the ones that come with it. The cutting edge on the included...

I think the round cutter would work, but full disclosure, I've never tried it.

I'm in the 3-Ring binder camp. I often write notes on them to help me make repeats - drill size tweaks, varied order of assembly, etc. -...

Like John said. Unless it is punky soft or otherwise obvious that it needs to be stabilized, I simply turn and finish a pen to see how...

I've done this several times in the past - usually when I was using CA to glue the tubes in and a tube would seize up before it was...

Thanks, John. Might be a misunderstanding here. Looking to insert two short tubes from either end to meet somewhere in the blank. How...

Started making some LED candle lanterns out of various wood types (Cedar, Cherry, Maple,. Walnut and Oak) and now starting on some...

I have successfully done it a time or two. Make sure the tubes at the join are clean and smooth and without any burrs. Epoxy MUST be...

I’ve never seen a list of either. Usually it’s a choice based on the condition of the wood and what you’re doing with it. Most can be...

Started making some LED candle lanterns out of various wood types (Cedar, Cherry, Maple,. Walnut and Oak) and now starting on some...