Where can I find an El Grande front section only?

Signed-In Members Don't See This Ad
Carl Fisher

Carl Fisher

Member
Joined
Jun 7, 2011
Messages
2,792
Location
Cape Coral, FL
Had a CA incident that killed the entire plastic and gold section of an el grande. Does anyone know where I might be able to get just the front section? The black plastic and a gold tip for a roller ball.

Thanks!
 
Signed-In Members Don't See This Ad
You might want to get someone else to confirm this but I believe the Churchill/Windsor has the same front section. Assuming that is so you can find it here. Note too that this is a full brass section, not plastic.
 
Last edited:
If the one from the golden nib will not work I may have one in my parts box. I will look and see. email Anthony and ask him if his rollerball section will work for the el grande. I may have a churchill I could check. I'll check on that also. Look for a report later.
Do a good turn daily!
Don
 
Shawn, those would be good if it was a fountain that I killed. I'll keep those in mind for conversion possibilities.

JD, nice upgrade option. I'll have to keep that bookmarked for later as well.

Constant, pm on the way shortly.
 
Thank you Don Ward!

Also thank you to those who were willing to help as well. I learned a bit of a lesson about CA gassing out inside of a pen when you use a drop or two to seal a loose fitting part. Switched over to thread lock from now on.
 
You're welcome.

Yea, CA is not the best for this. Locktite red or blue is a better choice and cleans off very well. Even two part epoxy is a better choice.
Do a good turn daily!
Don

Carl Fisher said:
Thank you Don Ward!

Also thank you to those who were willing to help as well. I learned a bit of a lesson about CA gassing out inside of a pen when you use a drop or two to seal a loose fitting part. Switched over to thread lock from now on.
Click to expand...
 
You must log in or register to reply here.
Back
Top Bottom