I showed this a couple off days ago. I made a few modifications. The slots I routed in for the tape hubs was done straight down and that let the tape move up too much, so I made some keepers to keep that from happening. They are held in with one screw. If I were to make another one, I'd
rout the slots at an angle, so the keepers wouldn't be necessary. I also added some blades to cut the tape and they work very well. I bought them on amazon. 8 in a pack for ten bucks. The picture shows the hubs I made and the keepers. On the hubs, I glued the dowel on one side and the other just slips on.
rout the slots at an angle, so the keepers wouldn't be necessary. I also added some blades to cut the tape and they work very well. I bought them on amazon. 8 in a pack for ten bucks. The picture shows the hubs I made and the keepers. On the hubs, I glued the dowel on one side and the other just slips on.
