Still more mills

[TellicoTurning]

Also have 4 of the little 6" midi crank operated mills from PSI... these are about finished also... Walnut, Spalted Elm, Spalted sycamore and Bradford pear.

Not a lot of spalting in the sycamore, just a little around the bottom.

 

[PapaTim]

Those look good Chuck. The crank type mills are a fun project.

 

[Sataro]

Very nice looking Chuck. Nice looking display on your Etsy shop!

 

[TellicoTurning]

Thanks guys, I'm setting up tomorrow for a 2 day show at a local community center and in a pretty affluent area.. hopefully these will go over well.

 

[TellicoTurning]

Very nice looking Chuck. Nice looking display on your Etsy shop!

Thanks Billy,

BTW, watch out for the local gendarmes there... I have two nephews on the force, one city and one county Mountie.... :biggrin::biggrin: