super8mm
Member
Last week I had a problem with Epoxy inside some barrels, well I use round files and cleaned them up to where the trimmer bushings were a snug fit.
I finish one pen yesterday and it was OK, but today I finished a 2nd Tycoon and it felt snug when pressing the inserts in BUT. after unscrewing and screwing the cap on both ends one of the inserts popped out and I lost the spring
So my question is can I paint a thin layer of epoxy inside the end of the barrel and let it dry and then press it back together or just epoxy the insert in?
Thanks.
I finish one pen yesterday and it was OK, but today I finished a 2nd Tycoon and it felt snug when pressing the inserts in BUT. after unscrewing and screwing the cap on both ends one of the inserts popped out and I lost the spring
So my question is can I paint a thin layer of epoxy inside the end of the barrel and let it dry and then press it back together or just epoxy the insert in?
Thanks.