Sierra/brass tube

Signed-In Members Don't See This Ad
Status
Not open for further replies.
Rmartin

Rmartin

Member
Joined
Jan 14, 2007
Messages
1,263
Location
Columbus, Ga, USA.
Can someone tell me the size of the brass tube for the Sierra pen kit?

I have several kits, but for some reason don't have the brass tubes for them. I really don't want to place an order for 6 brass tubes, and I don't need any other supplies from AS/Berea right now. I do need to place orders with PSI and CSU. Is there a brass tube PSI or CSU carries that will work with the Sierra?

Thanks,
Rmartin
 
Signed-In Members Don't See This Ad
Thanks, but I don't have anything nearby.

I guess I can order some cigars with the order.

There has to be a kit I could steal some tubes that I have on hand while I wait. Are they 10mm tubes?
 
The tube has an OD of 0.406" and is 2.208" long. Sorry, Richard, I don't think there are any other kits that use that size tube except the Wallstreet II as previously mentioned and possibly the Sierra Vista. It is "NOT" a 10mm tube.....not quite, but much closer to 11mm.

The recommended drill bit size is 27/64"; but a "Z" bit or a 10.5 mm bit would probably be better fits.
 
Thanks very much Randy. That's just the info I was looking for. If you see this, could you tell me if you measured a tube, or did you find the information in a data base somewhere, and if so, where?
 
Woodcraft will sell you 5 Wallstreet II barrels for $2.99, which are the same as the Sierra, and ship them to you for another $6.99. They don't care about the size of your order, so why spend more money than you have to?
 
Status
Not open for further replies.
Back
Top Bottom