crashgtr
Member
Hi
It's been a while but I am finally back to making pens after a very long hiatus.
I have a cigar pen I made in 2002 come back to me because the pen tip will no longer stay extended and even when extended it does not stick out far enough. This was one of the very early pens I made with PR.
I tried replacing the transmission but that did not help. I am thinking I need to disassemble the bottom half of the pen but can't quite figure out how to do it.
The nib unscrews then I am left with a pressed part with threads on the top and the bottom of the bottom half. I have a puch kit but there is nothing for the punch to be able to push out since both sides are the same diameter.
Any suggestions?
I also have a sierra that was in the bottom of my laptop bag that came apart and won't go back together, the nib end suddenly doesn't seem to fit, it keeps falling out. The pen was fine before this, I was using it for about a month or 2.
Any suggestions?
Thanks!
It's been a while but I am finally back to making pens after a very long hiatus.
I have a cigar pen I made in 2002 come back to me because the pen tip will no longer stay extended and even when extended it does not stick out far enough. This was one of the very early pens I made with PR.
I tried replacing the transmission but that did not help. I am thinking I need to disassemble the bottom half of the pen but can't quite figure out how to do it.
The nib unscrews then I am left with a pressed part with threads on the top and the bottom of the bottom half. I have a puch kit but there is nothing for the punch to be able to push out since both sides are the same diameter.
Any suggestions?
I also have a sierra that was in the bottom of my laptop bag that came apart and won't go back together, the nib end suddenly doesn't seem to fit, it keeps falling out. The pen was fine before this, I was using it for about a month or 2.
Any suggestions?
Thanks!