Searching for Bandsaw jig

[avbill]

I looked through the library for a and saw jig that would cut predetermine angles. If any one knows where it ws put can you please post. Thank you!

 

[plano_harry]

Hi Bill, I was looking for the same thing and found a couple of good hits in Search. Here is one:
http://www.penturners.org/forum/f30/bandsaw-sled-cutting-pen-blanks-7167/

 

[plano_harry]

I think I saw one or two that allowed angles as well.

 

[Wildman]

If you have a sliding T-Bevel & protractor you can make either a fixed angle or movable angle sled in about ten minutes. I made a fixed angle sled so can cut boards on a bias. My camera EOS utility gave up the ghost so cannot post a picture. Here is an example of a completed pen.

Spalted Red Oak Sierra Pen - by Wildwood @ LumberJocks.com ~ woodworking community

I end up squaring up the blank using regular sled to cut off ends before sizing the blank.