larryc
Member
These are two videos that Tim Robertson and Randy Willis took in my shop and played them for the West Georgia Woodturners Association at the last meeting September 12th.
Penmaking Videos
- Thread starter larryc
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Bob in SF
Member
Fine videos, Larry!
Always a pleasure to see an expert craftsman at work - thanks!
Gratefully - Bob
Always a pleasure to see an expert craftsman at work - thanks!
Gratefully - Bob
WriteON
Member
Great video thanks. I use the same brush but run through manually with the bore rod. Those brushes work well. Base plate wax is a must have.
Great videos including tips.
I liked the jig used for cutting Blanks on the bandsaw. Interested in sharing the idea or plans for our library?
I liked the jig used for cutting Blanks on the bandsaw. Interested in sharing the idea or plans for our library?
ed4copies
Local Chapter Manager
"I use the light to remind me when the blade is under tension" (paraphrased)
Clean the inside with a gun brush, outside with abranet;
Yeah, I made this drawer to organize all my drill bits.
I have not had time to watch them completely--but the first 8 minutes gave me these nuggets that I will definitely add to my own shop.
THANK YOU< Larry
I will call you to get permission to link these from Exotics
Ed
Clean the inside with a gun brush, outside with abranet;
Yeah, I made this drawer to organize all my drill bits.
I have not had time to watch them completely--but the first 8 minutes gave me these nuggets that I will definitely add to my own shop.
THANK YOU< Larry
I will call you to get permission to link these from Exotics
Ed
Great videos sir !
Very much enjoyed both.
I have a feeling there will be some bolts for slimline assemblies being purchased and measured to the correct length after that great tip makes the rounds....aswell as probably a pen assembly press or two getting wall mounted...another great ideal, If I had one I would be.
Very much enjoyed both.
I have a feeling there will be some bolts for slimline assemblies being purchased and measured to the correct length after that great tip makes the rounds....aswell as probably a pen assembly press or two getting wall mounted...another great ideal, If I had one I would be.
larryc
Member
Many thanks for your kind comments.
However, I don't think there is an original thought here. I think everyone of these ideas has been previously published here on this forum.
Kudos to Jeff and the fine group of moderators.
However, I don't think there is an original thought here. I think everyone of these ideas has been previously published here on this forum.
Kudos to Jeff and the fine group of moderators.
Timber Ripper
Member
Thank you Larry for sharing. Great video and tips
larryc
Member
That is correct. I will only use bushings if the material to be turned is brittle - like acrylic - and is proud of the tube before I square off the ends to the tubes. Hope that make sense.